Services

AVOID SHUTDOWNS

It is important to address network and bus problems before they happen, all communication systems are subject to aging, there are many factors that may contribute to this effect: wear of connectors, wear of cables, corrosion, firmware updates, changes in electrical installation, etc. There is a recognizable curve to observe the behavior of a communication system when problems are solved once the show during a complete unforeseen shutdown:

But when we use the right tools and we benefit from a large knowledge database, it is possible to diagnose future problems by paying attention to the small deviation that a network/bus presents during normal operation, thus we can avoid undesirable shutdowns by helping a system to age correctly, we can visualize this effect in the following graph:

To avoid shutdowns, we offer the following services:

• Network/bus measurements
• Setup of network/bus permanent diagnostics devices
• Network/bus and complete control system early troubleshooting
• Network/bus and control system maintenance
• Intelligent network/bus maintenance planning
• Troubleshooting & Monitoring Tools Training

NEW SYSTEMS

When a new control system is being built, a detailed consideration of devices and control requirement must be taken, as well as good calculation for possible future growth, we have the right tools to simulate your network/bus architecture behavior:

Once a system is built, there is the need to check that the final implementation was made just as planned, and that it duly complies with applicable standards, there is the need of commissioning / certification of the system:

For new systems we help you with the following services:

• Network/bus topology consulting
• Network/bus elements selection
• Network/bus commissioning and/or certification

TROUBLESHOOTING

Unfortunately, there are times when it is impossible to check systems before they fail, or an old system is being received without further check, in those cases, you are not alone! We can assist you in case you are experiencing an unexpected system shutdown with the following services:

• Network/bus measurements
• Network/bus repair
• Control system verification
• Control system repair

TRAINING

There is nothing like having capable personnel ready for troubleshooting at all times, we can help you achieve that, and also to provide you the right tools to diagnose and fix any problem you may have with your Network/bus. We can provide the following training:

• Network/bus planning
• Specific tools training
• Fieldbus/Ethernet Communication Training (user)
• Fieldbus/Ethernet Communication Installer/engineer certification