PROFIBUS Diagnostic Connector Axial Fast Connect | 110050008
Accessories
$82.39
ⓘ Please contact us for partner and OEM pricing here.
PROFIBUS Diagnostic connector axial fast connect
The PG/Service interface serves as a feedback-free measuring point for PROFtest II XL/PROFI-TM Professional and PB-INspektor® NT and can also be used as a programming interface. The plug is completely shielded by the metal-coated casing, and the plug for the terminating resistor is accessible from outside, disconnecting the outgoing segment when in the ON position. The integrated 4 LEDs (Power, TxD, Termination, Error) serve for a quick diagnosis of the bus status. With the Error LED, for example, reflections and missing terminating resistors are signaled. The design meets the Fast Connect requirement.
Bus connection
- 9-pin sub-D interface
- Insulation piercing terminal (suitable for Fast Connect cable)
- Axial cable outlet
Electrical parameters
- Terminating resistor: integrated, can be switched with a sliding switch from outside
- Baud rate: 9.6 kbps to 12 Mbps
- Supply voltage: 4.75 to 5.25 VDC has to be provided by each PROFIBUS user (Pin 5 GND, Pin 6 +5V)
- Current drain: 10 ... 30 mA
- Diagnostic display through LED status
Ambient conditions
- Operating temperature: -20 °C to +75 °C
- Industrial protection: IP20
Design
- Dimensions (H x W x D): 34 x 15,8 x 64 mm
- Interface: 9-pin sub-D
- Weight: approx. 80 g
- Casing: zinc die cast
- Max. fastening torque: 0,02 Nm
